STANDGAS HC PRO
STANDGAS HC PRO is a stand-alone detector using catalytic technology for the detection of explosive gases and provided with a relay output.
Stand-alone functioning: no control panel required.
Available gases: methane-natural gas, butane-propane, hydrogen, heptane, hexane, pentane, methanol, styrene, ethane, ethanol, ethylene, propylene, acetone, ammonia, cyclohexane, cyclopentane, dioxane, butyl acetate, ethyl acetate, acetic acid, isobutyl alcohol, isopropyl alcohol, decane, benzene, octane, methyl ethyl ketone –butanone-, nonane, propanol, toluene, xylene and kerosene. For other gases, please ask.
Allows for the automatic selection of the gas to detect, from any of the available gases, through use of an established protocol using a jumper.
Detection range from 0 to 100% L.E.L.
Optical indication for status and sensor fault.
1 programmable relay output module in between 2 levels (20% LEL / 50% LEL), instant/ delayed disconnection, delay disconnection programming and initial relay idle state.
Power range 10V to 30V DC.
Sensor and compensator are independently encapsulated, ensuring higher linearity and stability.
Detector provided of sintered filter.
Calibrated at factory with target gas. No need to recalibrate at installation.
Simple verifying and maintenance procedures can be carried out by a single worker.
